Connecticut last May.
Below is an AP story on the proceedings. The NTSB hearing continues Thursday, and can be watched live via computer. Find the link here.
The accidents occurred on the New Haven Line, which Metro-North calls the busiest rail line in the country. It runs along Westchester’s Long Island Sound shore, from the Mount Vernon East station to Port Chester.
HARTFORD, Conn. (AP) — A Metro-North Railroad official on Wednesday told federal regulators investigating a major derailment and a fatal accident in May that the commuter line is behind schedule on some of its maintenance, has not updated certain standards in years and is losing experienced welders to retirement.
Chief Engineer Robert Puciloski, who appeared at the National Transportation Safety Board hearing in Washington, D.C., said the railroad is “behind in several areas,” including a five-year schedule of cyclical maintenance that had not been conducted in the area of the Bridgeport derailment since 2005.
“I cannot give you an answer as to how we got so far behind,” said Puciloski, adding that Metro-North is working to get its maintenance work back on schedule.
Wednesday marked the start of a two-day hearing that includes testimony on several issues, including track inspections and maintenance, passenger car safety standards, crashworthiness, policy and practice of worker protection and organizational safety culture. The NTSB has said the determination of a probable cause for each accident will be released when the investigations are complete.
On May 17 in Bridgeport, an eastbound train derailed and was struck by a westbound train, injuring 73 passengers, two engineers and a conductor. Eleven days later, on May 28, a track foreman, Robert Luden, was struck and killed by a train in West Haven. Luden had requested that the section of the track where he was working on be taken out of service.
NTSB Chairman Deborah Hersman said following Luden’s death the board issued an urgent recommendation to Metro-North that it use “redundant protection,” such as a procedure known as “shunting,” in which crews attach a device to the rail in a work zone. It alerts the dispatcher to inform approaching trains to stop. In June, Metro-North said it would start a pilot program using shunting devices.
Hersman offered Luden’s family condolences from the NTSB.
“We know that nothing can replace your loved one,” she said. “And our thoughts are with those who suffered injuries in the Bridgeport accident. Our goal is that throughout our investigation and our findings and recommendations we can prevent similar tragedies.”
A major focus of the morning session of Wednesday’s hearing was on a cracked joint, located near where the derailment took place. Puciloski said after a replacement joint was installed, a welding crew ground it down to a flat surface, believing they were complying with federal standards. But there was mismatch in the joint, he said.
Puciloski said the crews believed they had performed the task adequately, adhering to federal standards, but he said “there is no guidance indicating what the standard should be for a joint of that nature.”
Puciloski also said that the railroad is losing “a lot of experience in Metro-North and the people who know how to weld to this level are retiring.”
He said Metro-North is starting to develop a training program to boost its ranks of qualified welders. Also, Metro-North is reviewing its entire track inspection program since the two incidents, including how it inspects track and how often inspections should take place.
The post At accident hearing, Metro-North official says railroad is “behind” in maintenance appeared first on Commuter Life.